Rear Axle - 198RBI

Fig 1: Rear Reference Mark

Courtesy of CHRYSLER LLC

With transmission in neutral, position vehicle on hoist.
Position and secure a lift under the axle.
Mark propeller shaft flange (1) and axle pinion flange (2) for installation reference.
Remove propeller shaft and suspend under the vehicle.

Fig 2: Vent Hose
Courtesy of CHRYSLER LLC
Remove vent hose (1) from the axle tube (2).

Fig 3: Cable At Support Plate
Courtesy of CHRYSLER LLC
Remove park brake cables (1) from axle (2).
NOTE: Park brake cables are self adjusting and must be locked out before removal.

Fig 4: Rear Disc Brake Rotor
Courtesy of CHRYSLER LLC
Remove brake calipers (2) and rotors (1).

Fig 5: Rear Wheel Speed Sensor
Courtesy of CHRYSLER LLC
Remove brake sensors connector (1) from sensors (2).

Fig 6: Track Bar
Courtesy of CHRYSLER LLC
Remove track bar (1) from axle bracket (2)

Fig 7: Link
Courtesy of CHRYSLER LLC
Remove stabilizer bar links (1) from axle brackets (2).

Fig 8: Shock Absorber
Courtesy of CHRYSLER LLC
Remove shock absorbers (1) from axle brackets (2).

Fig 9: Upper Control Arms
Courtesy of CHRYSLER LLC
Remove upper control arms (1) from axle brackets (2).

Fig 10: Lower Control Arms
Courtesy of CHRYSLER LLC
Loosen lower control arm (1) bolts and lower axle enough to remove coil springs and spring insulators.
Remove lower control arm (1) from axle brackets (2).
Lower and remove the axle.