Axle Bearing And Seal

Fig 1: Dust Shield & Backing Plate

Courtesy of CHRYSLER LLC

Remove axle shaft from vehicle.
NOTE: Axle bearing race is a slip fit in the axle tube. No tool are required.
Remove brake dust shield (1) and support plate (2) from the axle.

Fig 2: Bearing And Seal
Courtesy of CHRYSLER LLC
Bearing retainer (1), axle bearing (2), axle shaft seal (3) and axle shaft retainer (4) are removed as an assembly.

Fig 3: Splitter 1130
Courtesy of CHRYSLER LLC
Remove bearing retainer (1) and bearing (2) with seal from axle with Splitter 1130 (3) and press. Position splitter between axle shaft retainer and tone ring and press assembly off shaft.