Single CARDAN Universal Joint

Fig 1: Stub Shaft Snap Rings

Courtesy of CHRYSLER LLC

NOTE: Saturate bearing caps with penetrating oil prior to removal.

Remove axle shaft.
Remove bearing cap snap rings (1) from stub shaft yoke (2) bearing caps.

Fig 2: Press Stub Shaft 1st Cup
Courtesy of CHRYSLER LLC
Position receiver/socket (2) and driver/socket (1) on stub shaft yoke (3) in press. Press bearing cup into receiver/socket (2).

Fig 3: Stub Shaft 1st Cup
Courtesy of CHRYSLER LLC
Remove bearing cap (1) from stub shaft yoke (2).

Fig 4: Press Stub Shaft 2nd Cup
Courtesy of CHRYSLER LLC
Position receiver/socket (2) under stub shaft yoke (3) remaining bearing cup and driver/socket (1) on U-joint cross in press. Press bearing cup into receiver/socket (2)

Fig 5: Stub Shaft 2nd Cup
Courtesy of CHRYSLER LLC
Remove bearing cap (1) from stub shaft yoke (2). Then remove stub shaft from U-joint cross.

Fig 6: Shaft Snap Rings
Courtesy of CHRYSLER LLC
Remove snap rings (1) from shaft yoke (2) bearing caps.

Fig 7: Press Shaft 1st Cup
Courtesy of CHRYSLER LLC
Position receiver/socket (2) and driver/socket (1) on shaft yoke (3) in press. Press bearing cup into receiver/socket (2).

Fig 8: Shaft 1st Cup
Courtesy of CHRYSLER LLC
Remove bearing cap (1) from shaft yoke (2).

Fig 9: Press Shaft 2nd Cup
Courtesy of CHRYSLER LLC
Position receiver/socket (2) under shaft yoke (3) remaining bearing cup and driver/socket (1) on U-joint cross in press. Press bearing cup into receiver/socket (2)

Fig 10: Shaft 2nd Cup
Courtesy of CHRYSLER LLC
Remove bearing cap (1) from shaft yoke (2). Then remove U-joint cross from shaft yoke.