LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Mechanical Brake System - Base (Service Information) >> Base - Service Information >> Parking Brake >> Lever >> Removal >> Park Brake Lever

Park Brake Lever

Fig 1: Floor Console 3
GC0063826Courtesy of CHRYSLER LLC
  1. Remove the center console (3). Refer to REMOVAL .
    Fig 2: Park Lever Lock Out
    GC0063827Courtesy of CHRYSLER LLC
  2. Lockout the parking brake lever by inserting a punch (1) in the hole on the lever and by pulling up on the cable (3) to loosen and provide some slack. See STANDARD PROCEDURE .
    Fig 3: Cable Front Mount
    GC0025510Courtesy of CHRYSLER LLC
  3. Disconnect the rear park cables (2) from the equalizer.
    Fig 4: Park Lever Lock Out
    GC0063827Courtesy of CHRYSLER LLC
  4. Disconnect the electrical connector (4).
  5. Disconnect the electrical wiring harness clip (5) on the side of the lever.
  6. Remove the four mounting nuts (2) for the park brake lever.
  7. Remove the lever from the vehicle.
scientia non olet · About LEMON Manuals