Rear Brake Cable

NOTE: Park brake system must be locked out for servicing. See STANDARD PROCEDURE .

Fig 1: Floor Console 3

Courtesy of CHRYSLER LLC

Remove the center console (3). Refer to REMOVAL .

Fig 2: Park Lever Lock Out
Courtesy of CHRYSLER LLC
Lockout the parking brake cable by pulling up on the brake cables at the equalizer (3) then installing or a suitable tool (1).

Fig 3: Cable Front Mount
Courtesy of CHRYSLER LLC
Remove the cables from the equalizer (2).
Remove the cables from the body bracket (1) using a wrench to fit the end of the cable snug to depress the tangs.

Fig 4: Cable Grommets
Courtesy of CHRYSLER LLC
Raise and support the vehicle.
Remove the cables and grommets (2) from the floor (1) of the vehicle.

Fig 5: Cable At Axle
Courtesy of CHRYSLER LLC
Remove the cable (1) from the axle bracket (2).

Fig 6: Cable At Support Plate
Courtesy of CHRYSLER LLC
Remove the brake cable (1) from the brake lever (2) at the support plate.