LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Mechanical Brake System - Base (Service Information) >> Base - Service Information >> Hydraulic/Mechanical >> Power Brake Booster >> Removal >> Power Brake Booster

Power Brake Booster

NOTE: LHD shown in graphics. The removal and installation procedures and torques specs are the same for the RHD.
  1. Remove the master cylinder.
  2. Disconnect vacuum hose from booster check valve.
  3. Remove retaining clip that secures booster push rod to brake pedal and slide the rod off the pin.
    Fig 1: Brake Booster
    GC0063824Courtesy of CHRYSLER LLC
  4. Remove the nuts (1) attaching booster mounting plate to the front cowl panel.
  5. In engine compartment, slide booster and mounting plate out of the cowl panel, and remove the booster assembly from engine compartment.
    Fig 2: Booster Mounting Plate
    GC0063825Courtesy of CHRYSLER LLC
  6. Remove booster mounting nuts (2) from the mounting plate (1).
  7. Disconnect the clutch pedal from the clutch M/C if equipped. 
  8. Remove the booster from the mounting plate (1).
scientia non olet · About LEMON Manuals