LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Mechanical Brake System - Base (Service Information) >> Base - Service Information >> Hydraulic/Mechanical >> Disc Brake Calipers >> Removal >> Disc Brake Caliper - Rear

Disc Brake Caliper - Rear

Fig 1: Caliper Mounting
GC0025481Courtesy of CHRYSLER LLC
  1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
  2. Raise and support vehicle.
  3. Remove rear wheel and tire assembly.
  4. Drain small amount of fluid from master cylinder brake reservoir with a clean  suction gun.
  5. Bottom caliper pistons into the caliper by prying the caliper over.
  6. Remove brake hose banjo bolt (3) and discard gasket washers.
  7. Remove the caliper slide pins (2).
  8. Remove caliper from the adapter.
  9. Remove the brake pads.
scientia non olet · About LEMON Manuals