LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio System & Video System - Electrical Diagnostics >> Audio/Video Systems - Electrical Diagnostics >> DTC Troubleshooting >> B1461-Channel 1 Audio Speaker Output Circuit Low >> Diagnostic Test

Diagnostic Test

  1. 1) CHECK FOR AN INTERMITTENT CONDITION 

    Turn the ignition on, then off, and then on again.

    With the scan tool, read Amplifier DTCs.

    Does the scan tool display active: B1461-CHANNEL 1 AUDIO SPEAKER OUTPUT CIRCUIT LOW? 

    Yes 

    1. Go to  2).

    No 

    1. The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
    2. Perform BODY VERIFICATION TEST - VER 1 .
  2. 2) CHECK THE (X201) AMPLIFIED LEFT FRONT I/P SPEAKER (+) CIRCUIT FOR A SHORT TO GROUND 
    Fig 1: Measuring Resistance Between Ground And Amplified Left Front I/P Speaker (+) Circuit
    GC0061340Courtesy of CHRYSLER LLC

    Turn the ignition off.

    Disconnect the Amplifier C2 harness connector.

    Disconnect the Left I/P Speaker harness connector.

    Measure the resistance between ground and the (X201) Amplified Left Front I/P Speaker (+) circuit.

    Is the resistance below 10K ohms? 

    Yes 

    1. Repair the (X201) Amplified Left Front I/P Speaker (+) circuit for a short to ground.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Go to  3).
  3. 3) CHECK THE (X291) AMPLIFIED LEFT FRONT I/P SPEAKER (-) CIRCUIT FOR A SHORT TO GROUND 
    Fig 2: Measuring Resistance Between Ground And Amplified Left Front I/P Speaker (-) Circuit
    GC0058811Courtesy of CHRYSLER LLC

    Measure the resistance between ground and the (X291) Amplified Left Front I/P Speaker (-) circuit.

    Is the resistance below 10K ohms? 

    Yes 

    1. Repair the (X291) Amplified Left Front I/P Speaker (-) for a short to ground.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Go to  4).
  4. 4) CHECK OPERATION OF THE AMPLIFIED LEFT FRONT I/P SPEAKER 
    Fig 3: Measuring Resistance Of Speaker Circuit Between Amplifier C2 Harness Connector And Ground
    GC0061341Courtesy of CHRYSLER LLC

    Reconnect and reinstall the Left Front I/P Speaker.

    Measure the resistance of the speaker circuit between the Amplifier C2 harness connector and ground.

    Is the resistance below 10K ohms? 

    Yes 

    1. Replace the Left Front I/P Speaker in accordance with the service information.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Replace the Amplifier in accordance with the service information.
    2. Perform BODY VERIFICATION TEST - VER 1 .
scientia non olet · About LEMON Manuals