Diagnostic Test

1) TEST ANTENNA
Turn the ignition off.

Disconnect the Radio Antenna connector.

Inspect the Radio Antenna connection.

Was the Antenna connection clean and secure?

Yes
1. Go to 2).
No
1. Repair the Antenna connection as needed.
2. Perform BODY VERIFICATION TEST - VER 1 .
2) ANTENNA
Refer to AUDIO/VIDEO SYSTEMS - SERVICE INFORMATION and test the antenna in accordance with the Service Procedure.

Is the Antenna OK?

Yes
1. Go to 3).
No
1. Repair or replace the Antenna assembly in accordance with the Service Information.
2. Perform BODY VERIFICATION TEST - VER 1 .
3) RADIO
NOTE: Reconnect all previously disconnected components.

NOTE: Move vehicle outside approximately 30 ft. (9.14.m) from any structure.

Turn the ignition on.

Turn the Radio on.

With the scan tool, clear all DTC's, put the Radio in seek up and down mode for 2 loops around the band cycle before proceeding.

With the scan tool, read DTC's.

Does the scan tool display active: B142D-AUDIO ANTENNA NOT CONNECTED?

Yes
1. Replace the Radio in accordance with the Service Information.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Test Complete.