LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio System & Video System - Electrical Diagnostics >> Audio/Video Systems - Electrical Diagnostics >> DTC Troubleshooting >> B142F-Satellite Radio Antenna Not Connected >> Diagnostic Test

Diagnostic Test

  1. 1) TEST ANTENNA 

    Turn the ignition off.

    Disconnect the Satellite Radio Antenna connector.

    Inspect the Satellite Radio Antenna connection.

    Was the Antenna connection clean and secure? 

    Yes 

    1. Go to  2).

    No 

    1. Repair the Antenna connection as needed.
    2. Perform BODY VERIFICATION TEST - VER 1 .
  2. 2) SATELLITE RADIO ANTENNA 

    Refer to AUDIO/VIDEO SYSTEMS - SERVICE INFORMATION and test the antenna in accordance with the service procedure.

    Is the Antenna OK? 

    Yes 

    1. Go to  3).

    No 

    1. Repair or replace the Antenna assembly as necessary.
    2. Perform BODY VERIFICATION TEST - VER 1 .
  3. 3) SATELLITE RADIO RECEIVER 
    NOTE: Reconnect all previously disconnected components.
    NOTE: Move vehicle outside approximately 30 ft. (9.144 m) from any structure.

    Turn the ignition and radio on.

    With the scan tool, erase the audio DTC's, put the satellite radio in seek up and down mode for 2 loops around the band cycle before proceeding.

    With the scan tool, read the audio DTC's.

    Did this DTC reset? 

    Yes 

    1. Replace the Satellite Radio Receiver in accordance with the service information.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Test Complete.