Antenna Body & Cable
WARNING:
On vehicles equipped with airbags, (refer to RESTRAINTS - SERVICE INFORMATION
) before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.
- Disconnect and isolate the battery negative cable.
- Remove the glove box from the instrument panel. Refer to REMOVAL .
- Reach through the instrument panel glove box opening to unplug the two antenna coaxial cables in line connector.
- Unscrew the antenna mast from the antenna body base on the right outer cowl side panel.
- Using a trim stick, gently pry the edge of the antenna base trim cover to unsnap it from the antenna body base.
- Remove the three screws that secure the antenna body base to the right outer cowl side panel.
- From inside the passenger compartment, push the coaxial cable grommet on the antenna body half of the coaxial cable out through the hole in the right inner cowl side panel.
- From the outside of the vehicle, pull the antenna body base and cable assembly out through the hole in the right outer cowl side panel.