Odometer/Trip Odometer

The odometer and trip odometer give an indication to the vehicle operator of the distance the vehicle has traveled. This indicator is controlled by the instrument cluster circuitry based upon cluster programming and electronic messages received by the cluster from the Powertrain Control Module (PCM) over the Programmable Communications Interface (PCI) data bus.

The odometer and trip odometer information is displayed by the instrument cluster Vacuum Fluorescent Display (VFD) unit. The VFD will display the odometer information whenever the driver side front door is opened with the ignition switch in the OFF or ACCESSORY positions, and will display the last previously selected odometer or trip odometer information when the ignition switch is turned to the ON or START positions. The instrument cluster circuitry controls the VFD and provides the following features:

• Odometer/Trip Odometer Display Toggling  - Actuating the trip odometer reset switch button momentarily with the VFD illuminated will toggle the display between the odometer and trip odometer information. Each time the VFD is illuminated with the ignition switch in the ON or START positions, the display will automatically return to the last mode previously selected (odometer or trip odometer). The VFD can be reverted to the odometer display and any currently displayed textual messages suspended by momentarily depressing and releasing the odometer/trip odometer reset switch button.
• Trip Odometer Reset  - When the trip odometer reset switch button is pressed and held for longer than about two seconds with the ignition switch in the ON or START positions, the trip odometer will be reset to 0.0 kilometers (miles). The VFD unit must be displaying the trip odometer information in order for the trip odometer information to be reset.
• Communication Error  - If the cluster fails to receive an electronic distance  message during normal operation, it will hold and display the last data received until the ignition switch is turned to the OFF position. If the cluster does not receive a distance  message within one second after the ignition switch is turned to the ON position, it will display the last distance message stored in the cluster memory. If the cluster is unable to display distance information due to an error internal to the cluster, the VFD will display error  .
• Actuator Test  - Each time the cluster is put through the actuator test, the VFD will step sequentially through a display of 111111  through 999999  , then display the cluster software version number to confirm the functionality of each of the VFD unit segments and the cluster control circuitry.

The PCM continually monitors the vehicle speed pulse information received from the Body Control Module (BCM), then sends the proper messages to the ElectroMechanical Instrument Cluster (EMIC).

For proper diagnosis of the vehicle speed sensor, the BCM, the PCM, the EMIC, the PCI data bus or the electronic communication related to odometer/trip odometer operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.