LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.7L Engine (Service Information) >> Valve Timing >> Shaft-Idler >> Removal >> Idler Shaft

Idler Shaft

  1. Remove the primary and secondary timing chains and sprockets. Refer to TIMING CHAIN AND SPROCKETS .
    NOTE: To remove the idler shaft, it is necessary to tap threads into the shaft, to install the removal tool.
  2. Using a 12 mm X 1.75 tap, cut threads in the idler shaft center bore.
  3. Cover the radiator core with a suitable cover.
    CAUTION: Use care when removing the idler shaft, Do not strike the radiator cooling fins with the slide hammer.
  4. Using Slide Hammer 8517 remove the idler shaft.
scientia non olet · About LEMON Manuals