LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.7L Engine (Service Information) >> Engine Block >> Seal-Crankshaft Oil-Front >> Removal >> Crankshaft Oil Seal - Front

Crankshaft Oil Seal - Front

Fig 1: Crankshaft Damper - Removal
GC0003821Courtesy of CHRYSLER LLC
1 - SPECIAL TOOL 8513 I INSERT
2 - SPECIAL TOOL 1026
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt. Refer to REMOVAL .
  3. Remove A/C compressor mounting fasteners and set aside.
  4. Drain cooling system. Refer to STANDARD PROCEDURE .
  5. Remove upper radiator hose.
  6. Disconnect electrical connector for fan mounted inside radiator shroud.
  7. Remove radiator shroud attaching fasteners.
  8. Remove radiator cooling fan and shroud. Refer to REMOVAL .
  9. Remove crankshaft damper bolt.
  10. Remove damper using the Crankshaft Insert 8513A (1) and the Three Jaw Puller 1026 (2). See Fig 1.
    Fig 2: Crankshaft Front Seal Removal
    GC0003822Courtesy of CHRYSLER LLC
    1 - SPECIAL TOOL 8511
  11. Using Seal Remover 8511, remove crankshaft front seal (1). See Fig 2.
scientia non olet · About LEMON Manuals