LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.7L Engine (Service Information) >> Cylinder Head - Right >> Cover-Cylinder Head >> Removal >> Cylinder Head Cover

Cylinder Head Cover

  1. Disconnect battery negative cable.
  2. Remove air cleaner assembly, resonator assembly and air inlet hose.
  3. Drain cooling system, below the level of the heater hoses. Refer to STANDARD PROCEDURE .
  4. Remove accessory drive belt. Refer to REMOVAL .
  5. Remove air conditioning compressor retaining bolts and move compressor to the left.
  6. Remove heater hoses.
  7. Disconnect injector and ignition coil connectors.
  8. Disconnect and remove positive crankcase ventilation (PCV) hose.
  9. Remove oil fill tube.
  10. Un-clip injector and ignition coil harness and move away from cylinder head cover.
  11. Remove right rear breather tube and filter assembly.
  12. Remove cylinder head cover retaining bolts.
  13. Remove cylinder head cover.
scientia non olet · About LEMON Manuals