LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.7L Engine (Service Information) >> Cylinder Head - Right >> Cover-Cylinder Head >> Installation >> Cylinder Head Cover

Cylinder Head Cover

CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.
NOTE: The gasket may be used again, provided no cuts, tears, or deformation has occurred.
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gasket as necessary.
  2. Tighten cylinder head cover bolts and double ended studs to 12 N.m (105 in. lbs).
  3. Install right rear breather tube and filter assembly.
  4. Connect injector, ignition coil electrical connectors and harness retaining clips.
  5. Install the oil fill tube.
  6. Install PCV hose.
  7. Install heater hoses.
  8. Install air conditioning compressor retaining bolts.
  9. Install accessory drive belt. Refer to INSTALLATION .
  10. Fill Cooling system. Refer to STANDARD PROCEDURE .
  11. Install air cleaner assembly, resonator assembly and air inlet hose.
  12. Connect battery negative cable.
scientia non olet · About LEMON Manuals