LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.7L Engine (Service Information) >> Cylinder Head - Left >> Cover-Cylinder Head >> Removal >> Cylinder Head Cover

Cylinder Head Cover

Fig 1: Cylinder Head Cover - Typical
GC0003804Courtesy of CHRYSLER LLC
1 - SCREWS
2 - CYLINDER HEAD COVER
  1. Disconnect negative cable from battery.
  2. Remove the resonator assemble and air inlet hose.
  3. Disconnect injector connectors and un-clip the injector harness.
  4. Route injector harness in front of cylinder head cover.
  5. Disconnect the left side breather tube and remove the breather tube.
  6. Remove the cylinder head cover mounting bolts (1).
  7. Remove cylinder head cover (1) and gasket. See Fig 1.
NOTE: The gasket may be used again, providing no cuts, tears, or deformation has occurred.
scientia non olet · About LEMON Manuals