LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Electrical >> Motors, Switches, Relays >> Wiring Diagram Information >> Description >> Connector, Ground And Splice Information >> Identification

Connector, Ground And Splice Information: Identification

In-line connectors are identified by a number, as follows:

  1. In-line connectors located in the engine compartment are C100 series numbers.
  1. In-line connectors located in the instrument panel area are C200 series numbers.
  1. In-line connectors located in the body are C300 series numbers.
  1. Jumper harness connectors are C400 series numbers.
  1. Grounds and ground connectors are identified with a "G" and follow the same series numbering as the in-line connectors.
  1. Splices are identified with an "S" and follow the same series numbering as the in-line connectors. In addition, S001-S099 numbers are located in the engine compartment.
  1. Component connectors are identified by the component name instead of a number. Multiple connectors on a component use a C1, C2, etc. identifier.
scientia non olet · About LEMON Manuals