Single CARDAN Universal Joints

Fig 1: Cross In Yoke

Courtesy of CHRYSLER LLC

NOTE: This procedure describes a propeller shaft equipped a cardan joint in the tube yoke. For propeller shafts equipped with a companion/slip yoke, repeat the steps to remove the remaining cardan joint.

Apply (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores.
Position cross (1) in yoke (2) with lube fitting pointing up, if equipped.

Fig 2: Bearing On Cross
Courtesy of CHRYSLER LLC
Place a bearing cap (1) over the cross end (2) and align cap with yoke bore.
Press bearing cap into the yoke bore enough to clear snap ring groove.
Repeat step 3 and step 4 to install the opposite bearing cap.
NOTE: If joint is stiff or binding, strike the yoke with a soft hammer to seat the needle bearings.
Add grease to lube fitting, if equipped.