LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Differential & Driveline >> Propeller Shaft >> Shaft-Propeller Rear >> Installation >> Rear Propeller Shaft

Rear Propeller Shaft

Fig 1: Companion Flange
GC0024953Courtesy of CHRYSLER LLC
NOTE: Clean all propeller shaft bolts and apply Mopar® Lock & Seal Adhesive or Loctite® 242 to the threads before installation.
  1. Slide slip yoke on the transmission/transfer case output shaft. On 4x2 vehicles with a manual transmission install transmission flange bolts and tighten to 115 N.m (85 ft. lbs.).
  2. Align reference marks (3) on companion flanges (2) (4) and propeller shaft (1).
    Fig 2: Crimping Boot Clamp
    GC0024955Courtesy of CHRYSLER LLC
  3. Install companion flange bolts and tighten to 115 N.m (85 ft. lbs.).
  4. Tighten dust boot (3) clamps (4) if equipped with clamp installer (1).
scientia non olet · About LEMON Manuals