LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Axle Shafts >> Differential & Driveline >> Rear Axle - 8 1/4 >> Diagnosis And Testing >> Rear Axle - 8 1/4 >> Vibration

Rear Axle - 8 1/4: Vibration

Vibration at the rear of the vehicle is usually caused by:

  1. Damaged drive shaft.
  2. Missing drive shaft balance weight(s).
  3. Worn or out-of-balance wheels.
  4. Loose wheel lug nuts.
  5. Worn U-joints/CV joint.
  6. Loose/broken springs.
  7. Damaged axle shaft bearing(s).
  8. Loose pinion gear nut.
  9. Excessive pinion yoke run out.
  10. Bent axle shaft(s).

Check for loose or damaged front-end components or engine/transmission mounts. These components can contribute to what appears to be an axle vibration. Also look at engine accessories, brackets and drive belts.

NOTE: All driveline components should be examined before starting any repair.