C/V Joint-Inner

Fig 1: Inner C/V Boot

Courtesy of CHRYSLER LLC

Clamp shaft in a vise (with soft jaws) and support C/V joint (1).
Remove clamps with a cut-off wheel or grinder.
Slide boot down (2) the shaft.

Fig 2: Housing Snap Ring
Courtesy of CHRYSLER LLC
Remove lubricant from housing (1) to expose the C/V snap ring (2) and remove snap ring.

Fig 3: C/V Bearings
Courtesy of CHRYSLER LLC
Remove bearings (4) from the cage (1).
Rotate cage (1) 30° and slide cage off the inner race (2) and down the shaft (3).

Fig 4: Inner Race
Courtesy of CHRYSLER LLC
Remove spread inner race (1) snap ring (4) and remove race (1) from the shaft (3).
Remove boot from the shaft and discard.

Fig 5: Inner C/V Joint
Courtesy of CHRYSLER LLC
Clean and inspect housing (1), cage (2), bearings (3), housing snap-ring (4), inner race snap-ring (5) and inner race (6) for wear or damage.