Parking Brake Lever

Fig 1: Lever Mount

Courtesy of CHRYSLER LLC

1 - ELECTRICAL CONNECTOR

2 - PARK BRAKE LEVER ASSEMBLY

3 - CABLE

Install the parking brake lever assembly (2).
Install the parking brake lever assembly (2) to the mounting bolts and tighten the nuts to 16 N.m (140 in. lbs.). See Fig 1.
Engage the front cables (3) to the equalizer. See Figure.
Reconnect the parking brake lamp switch wire. See Figure.
If installing a new parking brake lever remove the pin that comes on the lever when shipped.
If you are reinstalling the original park brake lever remove the lock out device at this time.
Test the parking brake lever. See Fig 1.
Install the center floor console. Refer to INSTALLATION .