Rear Parking Brake Cables
Courtesy of CHRYSLER LLC
| 1 - SUPPORT PLATE |
| 2 - CABLE |
| 3 - ACTUATOR LEVER |
- Install the cables (2) into the axle bracket. See Fig 1.
- Reconnect the cable to the park brake lever (3). See Fig 1.
Courtesy of CHRYSLER LLC
| 1 - RETAINER CLIPS |
| 2 - CABLES |
- Push the cables (2) thru the floor and seat the tangs (1). See Fig 2.
Courtesy of CHRYSLER LLC
| 1 - PARK BRAKE CABLES |
| 2 - CARPET |
- Reconnect the two cables (1) to the front mount.
- Lay the carpet (2) back down in the rear. See Fig 3.
- Install the rear seat. Refer to INSTALLATION
.
Courtesy of CHRYSLER LLC
| 1 - PARKING BRAKE HANDLE |
| 2 - PUNCH |
| 3 - CABLE GUIDE |
| 4 - CABLE |
- Remove the lock out device (2) on the lever (1). See Fig 4.
- Adjust the park brake shoes. See ADJUSTMENTS .
- Test the parking brake.