LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Mechanical Brake System - Base (Service Information) >> Hydraulic/Mechanical >> Power Brake Booster >> Removal >> Power Brake Booster - RHD

Power Brake Booster - RHD

  1. Remove the air box. Refer to REMOVAL .
  2. Relocate the cruise control servo to gain access to the booster for removal.
  3. Remove the brake lines from the master cylinder.
  4. Remove the master cylinder. See REMOVAL .
  5. Disconnect vacuum hose from booster check valve.
  6. Remove knee blocker under the steering column. Refer to REMOVAL .
    Fig 1: Booster Push Rod
    GC0025494Courtesy of CHRYSLER LLC
    1 - BRAKE PEDAL
    2 - BOOSTER ROD
  7. Remove the brake light switch and discard. Refer to REMOVAL .
  8. Remove retaining clip that secures booster push rod (2) to brake pedal (1). See Fig 1.
    Fig 2: Booster Mounting
    GC0025493Courtesy of CHRYSLER LLC
    1 - BRAKE BOOSTER
  9. Remove nuts attaching booster (1) to the dash panel. See Fig 2.
  10. In engine compartment, slide booster studs out of dash panel, tilt booster upward, and remove booster from engine compartment.
scientia non olet · About LEMON Manuals