Power Brake Booster - LHD

Disconnect the wire to the fluid level switch at the bottom of the reservoir.
Remove the master cylinder. See REMOVAL .
Disconnect vacuum hoses from booster check valve.
Remove the brake lines from the master cylinder and the HCU (ABS vehicles only) or the junction block for clearance.
Disconnect the HCU from the mounts and move to the side for clearance of the booster.
Remove knee blocker under the steering column. Refer to REMOVAL .

Fig 1: Booster Push Rod
Courtesy of CHRYSLER LLC

1 - BRAKE PEDAL

2 - BOOSTER ROD
Remove the brake light switch and discard. Refer to REMOVAL .
Remove retaining clip that secures booster push rod (2) to brake pedal (1). See Fig 1.

Fig 2: Booster Mounting
Courtesy of CHRYSLER LLC

1 - BRAKE BOOSTER
Remove nuts attaching booster (1) to the dash panel. See Fig 2.
In engine compartment, slide booster studs out of dash panel, tilt booster upward, and remove booster from engine compartment.