LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Mechanical Brake System - Base (Service Information) >> Hydraulic/Mechanical >> Brake Lines >> Removal >> Rear Flex Hose

Rear Flex Hose

Fig 1: Brake Hose At The Body
GC0025463Courtesy of CHRYSLER LLC
1 - MOUNTING BOLT
2 - BRAKE HOSE
3 - BRAKE LINE
4 - COIL SPRING
  1. Install prop rod on the brake pedal to keep pressure on the brake system.
  2. Raise and support the vehicle.
  3. Remove the brake line (3) from the hose (2) at the body. See Fig 1.
  4. Remove the brake hose mounting bolt (1) at the top of the hose located at the body. See Fig 1.
    Fig 2: Brake Hose At The Axle
    GC0025462Courtesy of CHRYSLER LLC
    1 - REAR WHEEL SPEED SENSOR
    2 - BRAKE HOSE
    3 - VENT HOSE
    4 - BRAKE LINES
    5 - MOUNTING BOLT
  5. Remove the vent tube (3). See Fig 2.
  6. Remove the two brake lines (4) at the bottom of the hose located at the axle. See Fig 2.
  7. Remove the mounting bolt (5) for the brake hose (2) at the axle. See Fig 2.
  8. Remove the hose (2).
scientia non olet · About LEMON Manuals