LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Mechanical Brake System - Base (Service Information) >> Hydraulic/Mechanical >> Brake Lines >> Removal >> Front Brake Hose

Front Brake Hose

Fig 1: Inner Fender Brake Line
GC0025460Courtesy of CHRYSLER LLC
1 - BRAKE LINE
2 - UPPER CONTROL ARM MOUNT
  1. Install prop rod on the brake pedal to keep pressure on the brake system.
  2. Remove the brake line (1) from the brake hose inside the engine compartment by the front control arm bolt (2). See Fig 1.
  3. Raise and support vehicle.
    Fig 2: Front Brake Hose
    GC0025459Courtesy of CHRYSLER LLC
    1 - TOP OF FRONT BRAKE HOSE
    2 - WHEEL SPEED SENSOR WIRE
    3 - UPPER CONTROL ARM
  4. Remove the brake hose banjo bolt at the caliper.
  5. Remove the mounting bolt for the top of the brake hose (1) at the vehicle. See Fig 2.
  6. Remove the hose.
scientia non olet · About LEMON Manuals