LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Mechanical Brake System - Base (Service Information) >> Hydraulic/Mechanical >> Brake Lines >> Installation >> Rear Flex Hose

Rear Flex Hose

  1. Install the hose.
  2. Install the mounting bolt for the brake hose at the axle. See Figure.
  3. Install the two brake lines at the bottom of the hose located at the axle. See Figure.
  4. Install the vent tube. See Figure.
  5. Install the brake hose mounting bolt at the top of the hose located at the body. See Figure.
  6. Install the brake line to the hose at the body. See Figure.
  7. Lower the vehicle and remove the support.
  8. Remove the prop rod.
  9. Bleed the brake system. See STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals