LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock Brake System - Electrical Diagnostics >> Brakes - Abs Electrical Diagnostics >> DTC Troubleshooting >> C2205-Steering Angle Sensor Internal >> Diagnostic Test

Diagnostic Test

  1. 1) CHECK FOR A DTC C2205-STEERING ANGLE SENSOR INTERNAL 
    NOTE: This DTC must be active for the results of this test to be valid.

    Turn the ignition on.

    With the scan tool, read and record DTCs.

    With the scan tool, read and record Freeze Frame information.

    With the scan tool, erase DTCs.

    WARNING: Ensure brake capability is available before road testing.

    Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 25 km/h (6 and 15 mph.).

    Park the vehicle.

    With the scan tool, read and record DTCs.

    Does the scan tool display: C2205-STEERING ANGLE SENSOR INTERNAL? 

    Yes 

    1. Replace the Anti-Lock Brakes Module in accordance with the SERVICE INFORMATION.
    2. Go to  2).

    No 

    1. Perform the ABS Intermittent Condition diagnostic procedure in this Section.
    2. Refer to ABS INTERMITTENT CONDITION .
  2. 2) STEERING ANGLE SENSOR 

    Replace the Steering Angle Sensor in accordance with the SERVICE INFORMATION.

    Perform ABS VERIFICATION TEST .

    CAUTION: Ensure brake capability is available before road testing.

    Road test the vehicle over 25 km/h (6 and 15 mph).

    NOTE: Test drive the vehicle by turning the wheel left or right in a curving manner at a velocity between 10 and 25 km/h (6 and 15 mph). for set conditions to be met.

    With the scan tool, read ABS DTCs.

    Did DTC C2205-STEERING ANGLE SENSOR INTERNAL reset? 

    Yes 

    1. Test Complete.
scientia non olet · About LEMON Manuals