LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Body - Interior & Exterior >> Exterior >> Rear Wheelhouse Splash Shield >> Removal >> Rear Wheelhouse Splash Shields

Rear Wheelhouse Splash Shields

Fig 1: Rear Wheelhouse Splash
GC0025808Courtesy of CHRYSLER LLC
1 - SPLASH SHIELD
2 - PUSH PIN FASTENERS (2)
  1. Raise and support the vehicle. Refer to STANDARD PROCEDURE .
  2. Remove the wheel.
  3. Remove the two rivets connecting the shield to the side sill molding.
  4. Remove the four rivets connecting the flare molding to the shield.
  5. Remove the two push pin fasteners (2) and remove the shield (1).
scientia non olet · About LEMON Manuals