Front Wheelhouse Splash Shield

Fig 1: Front Wheelhouse Splash Shield Attachment Points

GC0025804

Courtesy of CHRYSLER LLC

1 - SPLASH SHIELD

2 - PUSH PIN FASTENER (1)

3 - PUSH PIN FASTENERS (2)

4 - PUSH PIN FASTENER (1)

Raise and support the vehicle. Refer to STANDARD PROCEDURE .
Turn wheel as necessary to gain access to fasteners.
Remove the four rivets connecting the flare to the splash shield.
Remove the rivet connecting the splash shield to the side sill molding.
Remove the three screw/rivets connecting the splash shield to the fascia.
Remove the four push pin fasteners and remove the splash shield.