LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster (Service Information) >> Instrument Cluster >> Disassembly >> Instrument Cluster >> Cluster Bulb

Cluster Bulb

NOTE: This procedure applies to each of the incandescent cluster illumination lamp and bulb holder units.
Fig 1: Removing/Installing Cluster Bulb
GC0026439Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the instrument cluster (1) from the instrument panel. See REMOVAL .
  3. Rotate the bulb holder (2) counterclockwise about sixty degrees on the instrument cluster circuit board.
  4. Pull the bulb and bulb holder straight out of the circuit board.
scientia non olet · About LEMON Manuals