Sunroof Operation: Notes
| 1 - DRAIN TROUGH |
| 2 - GLASS ASSEMBLY |
| 3 - SUN SHADE |
| 4 - WIND DEFLECTOR |
| 5 - MOTOR |
| 6 - MOTOR SCREWS (3) 3 N.m (26 in. lbs.) |
| 7 - GLASS ASSEMBLY SCREWS (4) 3.5 N.m (31 in. lbs.) |
| 8 - FRAME ASSEMBLY |
| 9 - BRACKETS |
| 10 - END CAPS |
The sunroof features a power sliding glass panel and a sunshade which can be manually positioned anywhere along its travel, rearward of glass panel front edge.
The sunroof is electrically operated from two switches located on the windshield header, between the map lamp. To operate the sunroof the ignition switch must be in either the Accessory or On/Run position. One switch (vent) is a push button type and opens the sunroof to the vent position only. The other switch (open/close) is a rocker type for opening and closing the sunroof. Pressing and releasing the open button once, the sunroof will express open and the wind deflector will raise. If the button is pressed a second time the sunroof will stop in that position. Pressing and holding the close button will close the sunroof. If the close button is released the sunroof will stop in that position. Also, by pressing the close button the sunroof will close automatically.