LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Commander Limited, 5.7 2, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (3.7L Engine (Service Information)) >> Cylinder Head >> Springs-Valve >> Removal >> Valve Springs And Seals

Valve Springs And Seals

WARNING: This page is about a different variant/trim than selected.
  1. Remove the cylinder head cover. See REMOVAL .
  2. Use the Remover/Installer 8516A to remove the rocker arms and the hydraulic lash adjusters.
  3. Remove the spark plug for the cylinder the valve spring and seal are to be removed from.
  4. Apply shop air to the cylinder to hold the valves in place when the spring is removed.
    NOTE: All six valve springs and seals are removed in the same manner; this procedure only covers one valve seal and valve spring.
  5. Using Valve Spring Compressor 8387, compress the valve spring.
    NOTE: It may be necessary to tap the top of the valve spring to loosen the spring retainers locks enough to be removed.
  6. Remove the two spring retainer lock halves.
    NOTE: the valve spring is under tension use care when releasing the valve spring compressor.
  7. Remove the valve spring compressor.
    NOTE: The valve springs are NOT common between intake and exhaust.
  8. Remove the spring retainer, and the spring.
  9. Remove the valve stem seal.
NOTE: The valve stem seals are common between intake and exhaust.
scientia non olet · About LEMON Manuals