LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Wrangler X, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Compass/Mini-Trip Computer >> Symptom: *TEMPERATURE DISPLAY INACCURATE OR INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC INFORMATION AND PROCEDURES - TEMPERATURE DISPLAY INACCURATE OR INOPERATIVE

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Disconnect the Ambient Temperature Sensor harness connector.
Measure the resistance of the Ambient Temperature Sensor between pin 1 and pin 2.
The Ambient Temperature Sensor should measure within the following values:
10°C (50°F) Sensor Resistance = 17.99k - 21.81k Ohms
20°C (68°F) Sensor Resistance = 11.37k - 13.61k Ohms
25°C (77°F) Sensor Resistance = 9.12k - 10.88k Ohms
30°C (86°F) Sensor Resistance = 7.37k - 8.75k Ohms
40°C (104°F) Sensor Resistance = 4.90k - 5.75k Ohms
50°C (122°F) Sensor Resistance = 3.33k - 3.88k Ohms
Does the Ambient Temperature Sensor resistance measure between the min/max specifications?
Yes --> Go To 2
No --> Replace the Ambient Temperature Sensor in accordance with the Service Information. NOTE: After any repair for an Ambient Temperature Sensor problem, the vehicle must be driven for more than 2 minutes to update the display.
Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Turn the ignition off.
Disconnect the Ambient Temperature Sensor harness connector.
Disconnect the Compass/Temperature Mirror harness connector.
Measure the resistance of the Signal circuit between the Ambient Temperature Sensor connector and the Compass/Temperature Mirror connector.
Is the resistance above 5.0 ohms?
Yes --> Repair the Ambient Temperature Sensor Signal circuit for an open. NOTE: After any repair for an Ambient Temperature Sensor problem, thee vehicle must be driven for more than 2 minutes to update the display.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 3		 All
3 Turn the ignition off.
Disconnect the Ambient Temperature Sensor harness connector.
Disconnect the Compass/Temperature Mirror harness connector.
Measure the resistance between ground and the Ambient Temperature Sensor Signal circuit.
Is the resistance below 5.0 ohms?
Yes --> Repair the Ambient Temperature Sensor Signal circuit for a short to ground. NOTE: After any repair for an Ambient Temperature Sensor problem, the vehicle must be driven for more than 2 minutes to update the display.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 4		 All
4 Turn the ignition off.
Disconnect the Ambient Temperature Sensor harness connector.
Disconnect the Compass/Temperature Mirror harness connector.
Measure the resistance of the Sensor Ground circuit between the Ambient Temperature Sensor connector and the Compass/Temperature Mirror connector.
Is the resistance above 5.0 ohms?
Yes --> Repair the Ambient Temperature Sensor Ground circuit for an open. NOTE: After any repair for an Ambient Temperature Sensor problem, the vehicle must be driven for more than 2 minutes to update the display.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Replace the Compass/Temperature Mirror in accordance with the Service Information. NOTE: After any repair for an Ambient Temperature Sensor problem, the vehicle must be driven for more than 2 minutes to update the display.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals