LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Wrangler X, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Audio >> Symptom: NO ANTENNA CONNECTION >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC INFORMATION AND PROCEDURES - NO ANTENNA CONNECTION

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Disconnect the Radio Antenna connector.
Inspect the Radio Antenna connection.
Was the Antenna connection clean and tight?
Yes --> Go To 2
No --> Repair Antenna connection as needed.
Perform BODY VERIFICATION TEST - VER 1 .		 All
2 Refer to the AUDIO SYSTEM  in the service information and test the Antenna in accordance with the service procedure.
Is the Antenna ok?
Yes --> Go To 3
No --> Repair or replace the Antenna assembly as necessary.
Perform BODY VERIFICATION TEST - VER 1 .		 All
3
NOTE: Reconnect all previously disconnected components.
Turn the ignition and Radio on.
NOTE: Move vehicle outside approximately 30 ft. from any structure.
With the DRBIII®, erase the audio DTC's, put the radio in seek up and seek down mode for approximately 2 minutes before proceeding.With the DRBIII®, read the audio DTC's.Did this DTC reset?Yes --> Replace the Radio.Perform BODY VERIFICATION TEST - VER 1 .No --> Test Complete.		 All
scientia non olet · About LEMON Manuals