LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Wiper System & Washer System) >> Washer Nozzle >> Removal >> Rear

Washer Nozzle: Removal: Rear

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
  1. Using a trim stick or another suitable wide flat-bladed tool, gently pry the bottom of the rear washer nozzle away from the roof panel until the latch feature at the bottom of the nozzle that secures it in the mounting hole of the roof panel unsnaps.
  2. Pull the rear washer nozzle out from the roof panel far enough to access the washer hose. See Fig 1.
    Fig 1: Rear Washer Nozzle Remove/Install
    GC0026665Courtesy of DAIMLERCHRYSLER CORP.
    1 - NOZZLE
    2 - ROOF PANEL
    3 - HEADLINER HOSE
  3. Disconnect the washer hose from the barbed nipple on the back of the rear washer nozzle.
  4. Discard the rear washer nozzle.
scientia non olet · About LEMON Manuals