LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Wiper System & Washer System) >> Washer Nozzle >> Removal >> Front

Washer Nozzle: Removal: Front

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unlatch and open the hood.
  2. Remove both front wiper arms from the wiper pivots. (Refer to ELECTRICAL/FRONT WIPERS/WASHERS/FRONT WIPER ARM - REMOVAL) .
  3. Remove the cowl plenum cover/grille panel from over the cowl plenum. (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL) .
  4. From the underside of the cowl plenum cover/grille panel, disconnect the washer nozzle hose from the barbed nipple of the front washer nozzle. See Fig 1.
    Fig 1: Front Washer Nozzle Remove/Install
    GC0026663Courtesy of DAIMLERCHRYSLER CORP.
    1 - COWL GRILLE COVER (UNDERSIDE)
    2 - FRONT WASHER NOZZLE
    3 - WASHER NOZZLE HOSE
  5. From the underside of the cowl plenum cover/grille panel, release the integral snap features of the front washer nozzle and push the nozzle out through the mounting hole toward the top side of the cowl plenum cover/grille panel.
  6. Remove the front washer nozzle from the top of the cowl plenum cover/grille panel.
scientia non olet · About LEMON Manuals