Washer Nozzle: Installation: Rear
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
- Position the new rear washer nozzle to the roof panel. See Figure. Be certain that a new rubber gasket is in position on the back of the nozzle.
- Reconnect the washer hose to the barbed nipple on the back of the rear washer nozzle.
- Insert the rear washer nozzle supply hose and nipple into the mounting hole in the roof panel and align the nozzle with the hole.
- Engage the tab at the top of the nozzle behind the sheet metal at the top of the roof panel mounting hole.
- Using hand pressure, press firmly and evenly on the hood of the rear washer nozzle until the lower latch feature snaps into place behind the sheet metal at the bottom of the roof panel mounting hole.