Check Valve: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Unlatch and open the hood.
Remove both front wiper arms from the wiper pivots. (Refer to ELECTRICAL/WIPERS/WASHERS - FRONT/FRONT WIPER ARM - REMOVAL) .
Remove the cowl plenum cover/grille panel from over the cowl plenum. (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL) .

From the underside of the cowl plenum cover/grille panel, disconnect the cowl plenum and washer nozzle hoses from the three barbed nipples of the front check valve. See Fig 1.

Fig 1: Front Check Valve Remove/Install

Courtesy of DAIMLERCHRYSLER CORP.

1 - WASHER NOZZLE HOSE (RIGHT)

2 - FRONT CHECK VALVE

3 - COWL PLENUM WASHER HOSE

4 - ROUTING CLIP

5 - COWL GRILLE COVER (UNDERSIDE)

6 - WASHER NOZZLE HOSE (LEFT)

Remove the front check valve from the underside of the cowl plenum cover/grille panel.