Draining Water In Fuel
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - FUEL FILTER ASSEMBLY | 6 - FUEL FILTER |
| 2 - PRIMER BUTTON | 7 - FUEL TEMPERATURE SENSOR |
| 3 - FUEL SUPPLY TO HIGH PRESSURE PUMP | 8 - FUEL SUPPLY FROM TANK |
| 4 - FUEL HEATER | 9 - AIR BLEED SCREW |
| 5 - WIF SENSOR |
WARNING:
STORE FUEL IN APPROVED AND PROPERLY MARKED CONTAINERS. WEAR SAFETY GOGGLES AND ADEQUATE PROTECTIVE CLOTHING WHEN SERVICING FUEL SYSTEM.
- Disconnect the negative battery cable.
- Disconnect the water in fuel (WIF) wiring harness connector located under the fuel filter. See Fig 1.
- Connect a drain hose to the WIF sensor.
- Place the other end of the drain hose in a approved and properly marked container.
- Open the bleed screw on top of the fuel filter housing.
- Loosen the WIF sensor on the bottom of the fuel filter to begin draining.
- Allow the filter to drain into the container until fuel is visible.
- Tighten the WIF sensor, remove the drain hose and clean any spillage.
- Tighten the bleeder screw on top of the fuel filter housing.
- Connect the WIF wiring harness connector.
- Connect the negative battery cable.