LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 515 (Diagnosis & Overhaul - 545RFE Automatic Transmission) >> Automatic Transmission - 545RFE >> Planetary GEARTRAIN >> Disassembly

Planetary GEARTRAIN: Disassembly

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Reverse/Input Planetary Carrier Assembly
GC0005301Courtesy of DAIMLERCHRYSLER CORP.
1 - SNAP-RING 5 - INPUT PLANETARY CARRIER
2 - THRUST BEARING NUMBER 10 6 - INPUT SUN GEAR
3 - THRUST BEARING NUMBER 11 7 - REVERSE PLANETARY CARRIER
4 - INPUT ANNULUS
  1. Remove the snap-ring (1) holding the input annulus (4) into the input carrier (5). See Fig 1.
  2. Remove the input annulus (4) from the input carrier (5). See Fig 1.
  3. Remove the number 9 thrust bearing from the reverse planetary carrier. Note that this planetary carrier has four pinion gears.
  4. Remove the reverse planetary gear carrier (7). See Fig 1.
  5. Remove the number 10 thrust bearing (2) from the input sun gear (6). See Fig 1.
  6. Remove the input sun gear (6) from the input carrier (5). See Fig 1.
  7. Remove the number 11 thrust bearing (3) from the input carrier (5). See Fig 1.
scientia non olet · About LEMON Manuals