TEST ONE - SELECTOR IN MANUAL 1 (1st Gear)
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This test checks pump output, pressure regulation and condition of the low/reverse clutch hydraulic circuit and shift schedule.
- Attach pressure gauge to the low/reverse clutch tap.
- Move selector lever to the MANUAL 1 position.
- Allow vehicle wheels to turn and increase throttle opening to achieve an indicated vehicle speed to 20 mph.
- Low/reverse clutch pressure should read 115 to 145 psi.