LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Sunroof >> Glass Panel >> Adjustments >> Sunroof Glass Panel Adjustment

Sunroof Glass Panel Adjustment

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the sunshade rearward to the open position.
  2. Move the sunroof glass panel to the fully closed position.
  3. Adjust the glass one corner at a time.
    1. Loosen four glass screws. See Fig 1.
    2. Lift glass assembly and align the top of the glass panel to the top of the roof panel.
    3. Tighten screw to 3.5 N.m (31 in. lbs.).
    4. Repeat steps a. and b. for each corner of the glass panel.
    5. When properly adjusted, the front of the glass panel is 1.75 mm (0.07 in.) to 2.75 mm (0.11 in.) lower than the roof surface and the rear edge of the glass panel is 1.75 mm (0.07 in.) to .75 mm (0.03 in.) lower than the roof surface.
    NOTE: Glass assembly seal is 2.5 mm (0.1 in) higher than the glass panel. Measure at 300 mm (11.8 in) outboard of the centerline of the vehicle.
  4. Verify sunroof operation and alignment. Check fit and readjust as necessary.
Fig 1: Glass Panel
GC0025861Courtesy of DAIMLERCHRYSLER CORP.
1 - SCREWS
2 - GLASS PANEL
3 - MODULE ASSEMBLY
scientia non olet · About LEMON Manuals