LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Seats >> Seat Back - Rear >> Removal >> 60/40 Split Seat - Right

60/40 Split Seat - Right

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the outer seat belt anchors. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - REMOVAL) .
  2. Remove the outer seat anchor nut. See Figure.
  3. Remove the inner seat belt buckles. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT BUCKLE - REMOVAL) .
  4. Remove the front seat cushion hinge bolt. See Fig 1.
  5. Remove the center seat back hinge bolts and separate the rear seat assembly. See Fig 2.
  6. Remove the center seat belt anchor. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - REMOVAL) .
  7. Remove the remaining outer and inner seat anchor bolts. See Figure.
  8. Release the clips and remove the seat back hinge covers.
  9. Lift the seat cushion cover and remove the hinge bolts. See Fig 3.
  10. Remove the seat back.
Fig 1: Center Cushion Hinge
GC0025855Courtesy of DAIMLERCHRYSLER CORP.
1 - SEAT CUSHION
2 - BOLT
Fig 2: Center Seat Back Hinge
GC0025857Courtesy of DAIMLERCHRYSLER CORP.
1 - SEAT CUSHION
2 - BOLTS
3 - SEAT BACK HINGE
4 - SEAT CUSHION
Fig 3: Seat Back Hinge
GC0025856Courtesy of DAIMLERCHRYSLER CORP.
1 - SEAT BACK
2 - BOLT
3 - SEAT BACK HINGE
scientia non olet · About LEMON Manuals