Door - Rear: Latch: Adjustments: Adjustment
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Locate access hole and remove the mylar tape covering it. See Fig 1.
- Insert a 5/32-inch hex-wrench through hole and into adjustment screw. Loosen screw.
- Operate outside handle several times to release any restriction because of misalignment.
- Tighten adjustment screw to 3 N.m (30 in. lbs.).
- Test handle for proper operation.
| 1 - DOOR LATCH |
| 2 - MYLAR TAPE |
| 3 - ADJUSTMENT SCREW |