LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Vehicle Theft/Security >> Symptom List: BCM MESSAGE NOT RECEIVED (EXPORT ONLY); PRE-ARM TIMEOUT FAILURE (EXPORT ONLY) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - PRE-ARM TIMEOUT FAILURE

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRB, enter Body Computer.
Was the DRB able to I/D or communicate with the Body Computer?
Yes --> Go To 2
No --> Refer to the COMMUNICATION CATEGORY  for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1  .		 All
2 With the DRB, erase ITM DTC's.
Turn the ignition off.
Arm the VTSS and wait 1 minute.
Disarm the VTSS and turn the ignition on.
With the DRB, read Intrusion Transceiver Module DTC's.
Did this DTC reset?
Yes --> Replace the Intrusion Transceiver Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1  .
No --> The condition that caused this symptom is currently not present.
Inspect the related wiring harness for a possible intermittent condition. Look for any chafed, pierced or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1  .		 All
scientia non olet · About LEMON Manuals