LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *VF ODOMETER INOPERATIVE WITH DOOR OPEN >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC INFORMATION AND PROCEDURES CHART (VF ODOMETER INOPERATIVE WITH DOOR OPEN)

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Inspect the #4 fuse in the Fuse Block.
If the fuse is open, replace with proper rated fuse.
NOTE: Ensure that the ignition is in the off position.

Open the door(s).
Inspect the #4 fuse in the Fuse Block.
Is the fuse open?
Yes --> Go To 2
No --> Go To 3		 All
2 Turn the ignition off.
Disconnect the Instrument Cluster C2 harness connector.
Check connectors - Clean/repair as necessary.
Measure the voltage between the Door Ajar Switch Sense circuit and ground.
NOTE: This test will work for either the Driver or Passenger Door Ajar Switch Sense circuit.

Is there any voltage present?
Yes --> Repair the Door Ajar Switch Sense circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 3		 All
3 Turn the ignition off.
Disconnect the Door Ajar Switch harness connector.
NOTE: This test will work for the Driver or Passenger Door Ajar Switch.

Connect a jumper wire between cavity 1 and cavity 3.
Does the VF Odometer illuminate?
Yes --> Replace the inoperative Door Ajar Switch in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 4		 All
4 Turn the ignition off.
Disconnect the Door Ajar Switch harness connector.
Connect a jumper wire between the Door Ajar Switch Sense circuit and ground.
NOTE: This test will work for the Driver or Passenger Door Ajar Switch Sense circuit.

Does the VF display illuminate?
Yes --> Go To 5
No --> Repair the Door Ajar Switch Sense circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .		 All
5 Turn the ignition off.
Disconnect the Door Ajar Switch harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Door Ajar Switch Ground circuit.
NOTE: This test will work for the Driver or Passenger Door Ajar Switch.

Is the resistance below 5.0 ohms?
Yes --> Replace the Instrument Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Repair the Door Ajar Switch Ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals