LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *FOG LAMP INDICATOR INOPERATIVE - DOMESTIC >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC INFORMATION AND PROCEDURES CHART (FOG LAMP INDICATOR INOPERATIVE - DOMESTIC)

TEST ACTION APPLICABILITY
1
NOTE: Ensure that the Fog Lamps operate properly. If not, refer to EXTERIOR LIGHTING in the Service Information.
NOTE: The Headlamps must be on Low Beam for indicator to operate.
Turn the ignition off.Disconnect the Instrument Cluster.Check connectors - Clean/repair as necessary.Turn the Headlamps on and actuate the Fog Lamps.Using a 12-volt test light connected to ground, check the Fog Lamp Indicator circuit.Does the test light illuminate brightly?Yes --> Replace the Instrument Cluster in accordance with the Service Information.Perform BODY VERIFICATION TEST - VER 1 .No --> Repair the Fog Lamp Indicator circuit for an open.Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals